C L E A N I N G A N D P R E V E N T I V E M A I N T E N A N C E
Copyright © 2006, Cognitive - 1.800.525.2785
118
1 0 5 - 1 6 9 - 0 3
9.
Remove the front bezel. See the front bezel removal section of the enclosure
removal section.
10.
Slide the right side platen bearing past its plastic snap, toward the front of
the printer.
11.
Slightly bias the enclosure away from the left side of the platen. Slide the left
side of the platen out of its plastic snap, toward the front of the printer.
CAUTION:
BE CAREFUL NOT TO LOSE THE BEARING FROM THE RIGHT SIDE OF
THE PLATEN. THERE ARE NO RETENTION FEATURES WHICH WILL HOLD THE
BEARING ON THE PLATEN SHAFT AFTER THE PLATEN HAS BEEN REMOVED.
