MVS-8100 Hardware Description
3
48
Cognex MVS-8100M Hardware Manual
Jumper Settings for the 8100
Table 18 lists the jumpers on the original MVS-8100 and describes how they are used.
To locate the jumpers on the 8100, refer to Figure 14 on page 33. On the 8100, pin 1 is
to the left of all horizontal jumper blocks, and is at the top of all vertical jumper blocks.
Jumper Settings for the 8100M and 8100M+
Table 19 lists the jumper settings for both styles of 8100M and the 8100M+ and
describes how they are used. To locate jumpers:
•
on the 8100M, style A, refer to Figure 15 on page 34
•
on the 8100M, style B, refer to Figure 16 on page 35
•
on the 8100M+, refer to Figure 17 on page 36
.
Jumper
Block
Number
of Pins
Default
Setting
Purpose
J3
3
2-3
Selects source of +12 V power. On the original
8100, do not change this jumper from its default
position, which requires the use of the power
cable, P/N 300-0175.
JP1, JP2,
JP4, JP5
2
Closed
Jumper’s presence or absence selects 75
Ω
or
high impedance termination, respectively, of
the board’s four camera ports. (See
Camera
Port Termination Jumpers
on page 41 for
further information.)
JP3
2
Closed
Reserved for internal use. Do not remove this
jumper.
JP6, JP7
3
2-3
Reserved for internal use. Jumpers must cover
pins 2-3.
Table 18. Jumper settings for original 8100
