Installing the MVS-8100M
1
14
Cognex MVS-8100M Hardware Manual
7.
Connect your camera(s) to the 8100 using the appropriate camera cable, as listed
in Table 20 on page 51. Figure 4 shows the location of the camera ports on the back
panel of the 8100.
Figure 4.
MVS-8100 external connector location
Note
The 8100’s camera connectors are similar to the connector for a
standard VGA monitor. Attaching a VGA monitor cable to a camera
connector can cause the board to malfunction. However, the
PolySwitch resettable fuse on the camera port should protect the
board from permanent damage. Normal operation is restored after
the incorrect connection is removed.
8.
If you are installing one of the following cameras with the MVS-8100M or
MVS-8100M+, see the additional instructions in
Using Rapid Reset Cameras
on
page 17.
•
Sony XC-55 or XC-55 BB camera
•
Sony XC-ST50 or XC-ES50 camera with switch settings in rapid reset mode
•
Pulnix TM-9701 with CCF video format (MVS-8100M+ only)
C
A
M
0
C
A
M
1
MON
