EN
18
Cleaning the device
1. Clean the permanent
fi
lter, the permanent
fi
lter holder, the ceramic and thermo cup
with warm water and a small amount of detergent.
2. Thoroughly dry the permanent
fi
lter, the permanent
fi
lter holder, the ceramic and the
thermo cup.
3. Place the permanent
fi
lter and permanent
fi
lter holder back in the device once it is
completely dry.
4. Before
fi
rst use, we recommend
fi
lling the water tank two to three times, each time
allowing the water to circulate (
without coffee powder / coffee pad
) in order to rin-
se out the lines etc. and remove any production residue (see chapter „Use“).
The device is equipped with an overheat protection. Wait a few minutes before
you repeat the cleaning process.
Use
ATTENTION!
■
The device has overheat protection that prevents reactivation directly after the brew-
ing process for reasons of safety. Therefore, wait a few minutes after the brewing
process for the device to cool down before starting another brewing process.
■
Do not leave the device unattended so that you can immediately intervene in the
event of malfunctions (e. g. over
fl
owing etc.).
■
Caution: Risk of emitted steam! Never open the water tank cover when the device is
in use! Hot steam or hot splash water may escape.
■
Before start-up, make sure that the water tank cover is closed and the permanent
fi
lter as well as the permanent
fi
lter holder have been correctly inserted so that the
water is able to circulate through the coffee powder / coffee pad without any obst-
ructions.
■
Do not add any water to the coffee maker once it has been turned on. You could
scald yourself with the sudden emission of steam.
■
Never use the device with an empty water tank; the pump could be damaged if the
device is operated without water.
■
Do not over
fi
ll the permanent
fi
lter to prevent the
fi
lter from over
fl
owing.
■
Do not over
fi
ll the water tank to prevent the thermo cup / ceramic cup from over
fl
ow-
ing! Always
fi
ll the water tank with an amount of water that the cup located under the
coffee spout is capable of holding!
1. Place the device on a dry, level and heat-resistant base.
2. Open the water tank cover and add some water to the water tank.
3. Place the permanent
fi
lter holder in the
fi
lter compartment.
4. Place the permanent
fi
lter in the permanent
fi
lter holder.
5. Add a coffee pad or loose coffee grounds to the permanent
fi
lter.
Vary the number of coffee pads or amount of coffee grounds to suit your taste and
the size of the coffee cup. We recommend using two coffee pads or one heaping
coffee spoon per ceramic cup or thermo cup.
06458_DE-EN-FR-NL_A5_V1.indb 18
06458_DE-EN-FR-NL_A5_V1.indb 18
18.11.2015 15:40:36
18.11.2015 15:40:36
