55
Safety:
1.
The projector must always be installed with bolts, clamps, or other fixing devices
which are suitably rated to support the weight of the projector.
2.
Always use a secondary safety fixing device with chain or steel wire of a suitable
rating to sustain the weight of the unit in case of failure of the principal fixing point.
3.
The external surfaces of the unit, at various points, may reach 60°C. Never handle
the unit until at least 10 minutes have elapsed since the LED was turned off.
4.
Never install the fixture in an enclosed area lacking sufficient air flow; the room
temperature must not exceed 35°C.
5.
The projector contains electronic and electrical components which must under no
circumstances be in contact with water, oil or any other liquid. Failure to do so will
compromise the proper functioning of the projector.
2.2
Warranty conditions
1.
The fixture is under warranty for 36 months from the purchase date against factory defections.
2.
Damage ought to unskillfulness, inappropriate use, or lack of suggested maintenance are excluded
from the warranty.
3.
Warranty expires when the projector is opened by unauthorized personnel.
4.
Warranty doesn’t include the replacement of the fixture.
5.
Serial number and model of the fixture are necessary to retrieve informations and assistance from
the dealer.
2.3
EC Norms
The projector meets all fundamental applicable EC requirements.
3.
The level of technology of
Risalto Led S
requires the use of specialised personnel
for all service applications; refer all work to your authorised
Coemar
service centre.
4.
A good earth connection is essential for the proper functioning of the projector.
Never connect the fixture if there is no earth connection.
5.
Mains cables must not come into contact with other cables.
6.
Do not operate the projector with wet hands or in an area where water is present.
7.
The fixture must never be located in an exposed position, or in areas of extreme
humidity.
