14
14
A00 1
7
. Turning the projector on
After having followed the preceding steps described, proceed with the power supply and turn on the
projector connecting it to the mains power.
The software version installed on the internal microprocessors will be shown on the display, suddenly it
will show the current DMX addressing. If the address blinks, it means that the DMX signal has not been
received. Check the connection cable and the mixer functioning.
7.1
DMX address of the unit
Each projector can use 5 or 1 address channels for its complete operation and is controlled by a DMX
512 signal.
DMX addressing
When powered up initially, each projector will show “A001”, which indicates that the fixture will start
responding from the first DMX channel;
Risalto Led S
also uses 5 DMX channels, which means that it
will respond to the commands from channel 1 to channel 5 of your DMX 512 controller. Accordingly a
second unit should be addressed as A006, a third one as A011 and so on. The operation must be carried
out on every
Risalto Led S
which has an address different from A001.
Altering the DMX address:
1.
Press the + or – button until the display shows the required DMX address. The digits on the display
will blink to indicate that the variation has not been registered.
2.
Press the enter key to confirm your selection. The digits on the display panel will cease to blink and
the projector will now respond to the new address.
Note:
by holding the + or – button down the scrolling will be faster; thus allowing a faster
selection
Warning!
If you alter the DMX address with no DMX signal connected, the digits on the display
panel will continue to flash even after you have pressed ENTER button to confirm the
address.
