Coemar Reflection FullSpectrum, Instruction Manual

Page: 8 / 26

English
9
4.3 Adjusting unit’s tilt
In order to adjust the tilt of the unit laying on the floor or hanged on a truss, simply untight the side handle adjust the tilt and lock the
yoke again by tightening the handle again.
WARNING !
The unit never should be used upside-down; .the arrows printed on the back of the unit indicate its upper side, do not
use the unit if the arrows aim downwards. The unit allows an excursion angle of 150°.
5. Powering up
5.1 Operating voltage and frequency.
The unit may operates at voltages ranges from 90 to 250VaC at a frequency of 50 or 60 Hz. It is not needed to effect any setup
procedures:
Reflection will automatically adjust its operation to suit any frequency or voltage within this range.
5.2 Connection to mains power
Mains cable characteristics
The mains cable provided is thermally resistant, complying to the most recent International standards.
Note: in case of cable replacement, similar cable with comparable thermal resistant qualities must be used exclusively (cable 3 X
1,5 ø external 10 mm, rated 300/500V, tested to 2 KV, operating temperature
- 40°C + 180°C, Coemar cod. CV5311).
Connection to mains power
Reflection is equipped with two power connectors, one as input and one as output, which can be used to connect more fixtures in
series (no more than 16 units @ 230V or 8 units @ 115V.).
The max absorption of
Reflection is reported in the following table:
-230/240V 0,88 A constant during normal exercise.
-100/115V 2,14 A constant during normal exercise.
WARNING !
Never link more than 16 units at 230 V or 8 units at 115 V.