5. Mounting the unit
mounting position
coemar nat mm 1200 ZOOM 15/30°
can operate in any mounting position.
protection against liquids
The projector contains electric and electronic components that must not come into
contact with water, oil, or any other liquid.
positioning the lamp
Ensure that the
coemar nat mm 1200 ZOOM 15/30°
is always operated with the
lampbase at the bottom of the unit. Failure to do so will result in excessive overheating
of the lamp and the unit, and can result in a dramatic reduction of lamp life.
vertical movement
The yoke attached to the
coemar nat mm 1200 ZOOM 15/30°
is tightened
into position via the T-handles provided. To adjust the position of the fixture, loosen
the handles slightly and locate the fixture at the required angle. When this is achie-
ved, retighten the handles firmly.
A stop mechanism allows vertical movement in the range of +/- 45°.
coemar nat mm 1200 ZOOM 15/30°
should always be mounted in the hori-
zontal plane.
adjusting the position of the mounting brackets on the projector body
coemar
positions the mounting brackets on the projector to ensure correct balance.
For particular applications, it is possible to reposition the mounting bracket laterally
along the length of the projector
Loosen the M8 bolts (A) and the M10 screws (B), which fix the mounting plate (C), to
the projector body, loosening, if necessary, the four M6 screws (D) which fix the
carry handles.
Reposition the mounting plate (E), in the desired position, then replace and tighten
the bolts and screws, (B), (A) and (D).securely.
mounting
The yoke is provided with three unthreaded ø 13,5mm holes as the mounting points
for hookclamps (cod.071) or suchlike.
Ensure that your hookclamps are sufficiently strong to support the weight of the
coemar nat mm 1200 ZOOM 15/30°
.
safety chain
The use of a safety chain (cod. 069) - fixed to the
coemar nat mm 1200 ZOOM
15/30°
and to the primary suspension point, is highly recommended to protect
against accidental failure, however unlikely, of the primary suspension point.
If using an after-market safety chain, not manufactured by
coemar
, ensure that it is
of sufficient strength to hold the weight of this fixture.
risk of fire
Each fixture produces heat and must be installed in a well-ventilated position. The
minimum recommended distance from flammable material is: 0.5m. Minimum
distance from the object being illuminated is: 1m.
mounting the ballast
The ballast is supplied with rubber feet (A) and with two threaded holes of ø10 and
ø12 (B) for the fitting of a hookclamp (cod.068) or (cod.071) and suchlike.
Ensure that your hookclamps are sufficiently strong to take the weight of the
coe-
mar nat mm 1200 ZOOM 15/30° ballast
.
D
D
C
E
A
B