10. DMX addressing
Each
coemar nat mm 1200 ZOOM 15/30°
utilises
18 channels
of
DMX
512
signal for complete control.
To ensure that each projector accesses the correct signal, it is necessary to correctly
address each fixture. Any number between 1 and 494 can be generated via the rear
multi-function panel of the
coemar nat mm 1200 ZOOM 15/30°
.
When powered up initally, each projector will display
A001
which indicates DMX
address 1; a projector thus addressed will respond to commands on channels 1
through 18 from the DMX 512 controller, a second projector should be addressed
as 19, a third as 37 and so on.
altering DMX addresses
1) Press the
+
or
-
buttons until the desired
DMX
number appears in the LED
display. The display will flash, indicating that the selection is not stored in
memory.
2) Press the
enter
button to confirm your selection; the display will stop flashing
and the projector will now respond to the new
DMX
address.
3) To better understand the function of each channel, we refer you to section 12
”Control channel functions from a DMX 512 contoller”.
Important Note
: Keeping the
+
or
-
pressed down will cause the display to alter at
increased speed, allowing a faster selection to be effected.
function display
menu
+
-
enter
