8
1. Basic Harness (B),
cont’d.
10/B Door Trigger 10K Pull-up Resistor (20 AWG) (YEL/WHT)
For vehicles with a door input battery saver mode (i.e., Ford Windstar,
Lincoln LS, Cadillac DeVille):
Connect the 10/B wire to a fused constant 12 volt source.
Note:
An internal 10k resistor will prevent the door input from going
into battery saver mode to prevent alarm falsing.
13/B Trunk Release Output +/- (16AWG) (TAN)
Locate the vehicle trunk release wire.
Verification:
Refer to the
Vehicle Wire Color and Location Chart
for the wire color, polarity, and location.
Connect the 13/B wire to the vehicle trunk release wire.
Note:
If the trunk release system is 5-wire type, refer to wire 9/A
(Advanced Harness).
IMPORTANT!
After installation, set the polarity of this circuit by moving the
fuse inside of the control module to positive (+) or negative(-).
15/B, 16/B
Siren Installation (20 AWG)
If you are installing a siren:
Mount siren with bell housing facing down.
Use at least two (2) screws to secure siren to mounting location.
Connect siren BLACK wire to 16/B BLACK Siren Drive.
Connect siren RED wire to a 15/B RED siren feed.
17/B, 18/B
Emergency Override Button (20 AWG-)
Find a mounting location for the override button that is not easily
seen or openly accessible. There must be at least 1" clearance
behind the location.
Drill a
9
/
32
" hole and mount the button.
19/B Hood Safety Input (20 AWG -) (GRAY)
Install the supplied pin switch and attach the 19/B wire.
Verification:
When connected, the 19/B wire will register ground
when the vehicle hood is opened.
CA-130 install rev 7-04.pmd
7/28/2004, 3:32 PM
8
