![background image](http://html1.mh-extra.com/html/cobra/cx50-jr-2015/cx50-jr-2015_owners-manual_2630602059.webp)
59
7. Clean any debris or particles from the bore and use some light emery cloth to
remove any scratches in the surface that the removal process may have
created.
8. Lubricate the bore with grease.
9. Prepare for assembly by installing the water pump assembly into the
assembly tool and align the tool with engine case making sure alignment pin
is in proper hole.
CAUTION:
Damage may occur if one attempts to install the water pump and the device is
not orientated correctly. If the tool does not sit flat against the cases, the
orientation of the tool to the engine is not correct. Make sure that the top
alignment pin is in the 2
nd
unthreaded hole, the bottom alignment pin is also in
the 2
nd
unthreaded hole, and that the relief for the stator bolt head is oriented
toward the stator.
10. Hold the installation tool firmly against the engine case and tap on the end of
the water pump shaft with a dead blow hammer until the insertion punch is
needed
11. Continue driving the assembly with the punch until the head is flush.
NOTE:
The insertion punch is 0.010” (0.25mm) longer than the housing so as to
seat the water pump assembly just in from the case surface.