![background image](http://html1.mh-extra.com/html/cobra/cx50-jr-2015/cx50-jr-2015_owners-manual_2630602052.webp)
52
2. Remove the clutch nut (not left hand thread) on the end of the crankshaft with
the clutch nut removal tool.
3. Attach the Universal Puller
.
There are
three 6mm clutch puller holes located on
the ends of the center hub. (figures 30 &
31)
4. Install each of the 3 6mm socket head cap
screws (clutch cover bolts can be used)
until each is similarly snug and the puller
looks square to the end of the crank
5. One at a time, tighten each of the 1/4 turn
until the clutch 'pops' off
Figure 30
Figure 31 Clutch puller installation
CAUTION:
Do not
use a jaw type puller.
CAUTION:
It is possible to cause damage to the piston when using the piston stop. Care
must be used when removing and installing the clutch arbor and using the piston
stop.
6. If necessary apply heat to the center clutch hub.
CAUTION:
Do not heat the crankshaft threads or the aluminum shoes.
7. Keep tension on the puller as you are heating it.
The clutch will often pop off under tension from the puller and it will be very hot.