56
Ignition
Stator care
Stator failure could result from running the bike hot. Following is a list of things
that will make your engine run hot.
1. The timing should not exceed the maximum specifications listed.
2. Improper carburetor jetting.
3. Improper spark plug heat range. Never run a hotter plug than the specified
spark plug.
4. Clutch slippage. See “CLUTCH” section for causes of slippage.
CAUTION:
•
Because of the amount of heat generated by the clutch and engine during
extended periods of riding, it is advisable to remove the ignition cover
afterward to allow the ignition to cool off. The heat transfers through the cases
and can damage the stator as it cools off because of lack of airflow around
the stator.
•
Ignition will overheat if the gap between the rotor and stator is not large
enough. There should be even clearance as the rotor rotates relative to the
stator.
•
Non-resistor spark plug caps should be used. Resistor caps will result in a
weaker spark that will reduce performance.
•
Make sure connections are free of dirt.
The proper ignition timing for this model of is at
0.040”
before Top Dead Center
(that means 0.040” before the piston reaches the highest point of it’s travel in the
cylinder).
CAUTION:
Advancing the ignition timing will cause the engine to run hotter, in-turn causing
power loss, shortened clutch life, and possibly lead to premature stator failure,
and can also cause detonation which can lead to premature piston and ring
failure.
Tools recommended for timing service:
•
Compact motorcycle dial indicator (ECMU0079)
•
Universal clutch puller- a universal puller that pulls the clutch, main drive gear
and rotor. (Part # MCMUTL70).
TIMING YOUR IGNITION:
1. Remove the spark plug.
2. Insert the dial indicator into the spark plug hole.
