11
Step Three
: Open Box B (Right Back Panel/Left Back Panel). Install Right Back Panel by sliding the Panel onto
the metal brackets located on the Floor Panel. After lining up the Right Back Panel to the Right Front Panel,
thread the Installation Bolts provided in the accessories box through the holes in panels and hand tighten
them. Set the Left Back Panel onto the Floor Panel (Note: there are no metal brackets on the left side of the
Floor Panel). After lining up the Left Back Panel with the Right Back Panel and the Left Front Panel, thread the
Installation Bolts provided through the holes in the panels and hand tighten them. A final tightening of the
Bolts will be performed later with a screwdriver after the sauna is completely assembled.
*Do not over tighten installation bolts. It will cause damage to the sauna cabin*
Step Four
:
From Box C, install the two Bench Support Panels by lining up the bench support panels and interior
wall magnets. Behind the right Bench Support Panel, connect the two 120 volt electrical cords. Make all four
120 volt, three prong electrical connections using the four-outlet receptacle located on the Left Wall Panel.
Summary of Contents for Delmar
Page 20: ...20 Control Panel Instructions ...