21
1.
POWER
– Press the Power Button (bottom right) to turn the sauna on.
2.
TIMER CONTROL
– Press the +/- time buttons to adjust the time. When the count down reaches 5
minutes, the sauna will beep 5 times and sauna will turn off when time reaches 0. The last set time is
memorized by. You may adjust the timer up or down at anytime during your sauna session.
3.
TEMPERATURE CONTROL
– The temperature will display Celcius when first turned on. To change to
Farenheit, press and hold both default without adjustment after startup. You may adjust the
temperature up or down at any time during your session. We recommend setting the time initially at
125-130 and adjust the sauna once you start your session.
4.
RESERVATION/TIMER MODE
– In standby mode (plugged in/power off), press the “timer” button. You
will see the time and temperature display light up for you to enter the reservation time. Press the
timer button to adjust the time from 1-23 hours (note – if set to “0”, the sauna will come on 24 hours
in the future. The numbers will blink for 8 seconds and then it is reserved to come on this many hours
in the future. Repeat the same for your desired temperature. To cancel reservation, press the timer
key to turn off.
5.
CHROMOTHERAPY LIGHTS
– Press the “chromo” button to turn the lights on/off. Press and hold for 3
seconds to control desired color. Once the display says “2n”, you can scroll through all 17 colors.
6.
LIGHT CONTROL
– In standby mode, press the light button to switch on and off inside and outside
lights. The lighting is automatically turned on when the sauna is turned on or ff when the sauna time is
over. Press the light button once to turn on and again to turn off. Press and hold for 3 seconds to
control the inside and outside lights independently.
7.
OUTSIDE LIGHTS
- Press the OUTSIDE button to turn on and off the outside lights
8.
OXYGEN IONIZER
- Not required unless you
9.
BLUETOOTH/SOUND SYSTEM
– Press the “music note” button on the top left, and you will see the
panel display “BLU” and you can then go to the settings on your mobile phone and click on “bt-audio”
to connect. During your session, when you select the music key the time display can adjust the volume
and the temp. display can adjust your music selection.
10.
OPERATIONAL CHECK
-
Once the sauna is assembled, a preset operation is recommended.
a.
Press sauna ON and adjust your time/temperature as usual.
b.
After 5 minutes, lightly touch each heater making sure you feel heat. Note, that the Infra-Tile
floor is a lower wattage for comfort and will take slightly longer to warm. If you feel a heater
not producing heat, then you will want to re check all of your heater connections on top
directly above that heater. These can easily be missed during the initial installation.
Summary of Contents for Delmar Series
Page 20: ...20 Control Panel Instructions ...
Page 22: ...22 Step Fourteen SWEAT ...
