CNI C(G)-310, Manual

Page: 11 / 12

C (G)-310 Main Frame Connector
- 11
comtestnetworks.com
8.2 Jumper field
: The connector panel is
permanently pre-marked in black numbers, with a
vertical black dividing line, adjacent to every 10
pairs of wire-wrap terminals on the right face of
the panel, to assist in quick pair identification
when placing CO jumpers (Figure 12).
8.3 Fanning strip : The fanning strip with holes
for entrance of the CO jumpers is on the front of
the panel immediately to the right of the wire-wrap
terminals. Each group of 10 cable pairs has two
large fanning strip holes to facilitate access of the
jumper wires from line terminal blocks to the
connector wire-wrap terminals (Figure 13). The
side of the fanning strip is also marked for 10
pairs.
8.4 Connection of Central Office to Outside
Plant: All that is required to make the final
connection is to push each protector module from the
detent position to the fully inserted position. The
outside plant and central office equipment are then
connected.