Introduction
1 - 4
IEEE 802.3 Fast
Ethernet
100Base-TX Four pairs of unshielded
twisted-pair 5 cable with
RJ-45 connector for
10/100Mbps
Note:
The cable length from the print server to hub/switch
must not exceed 300 feet (Approximately 100
meters)
Hardware Installation
To install the print servers, you need to complete these
steps:
˙
Confirm that your printer parallel port(s) work well.
˙
Connect the print server to the network and printer(s)
and plug in the print server.
˙
Generate a configuration page from the print server.
Follow these instructions to install the print servers, please
refer to any peripheral you are connecting to the print
server:
1. To ensure your printer(s) work well, do one of the
following:
˙
Send data through the parallel port of each printer you
are connecting to the print server, or
˙
Generate a printer self-test page.
2. Turn off the power for each printer.
3. Connect one end of the UTP cabling to the print server.
