Troubleshooting
9 - 13
You have to do the same "arp" command to specify an
entry on the NT/UNIX computer as a gateway in order
for it to forward your subsequent "ping" or/and "tftp"
commands to the print server.
b. If the gateway computer is a Novell NetWare file
server:
1. Due to the presence of this NetWare file server, the
IPX/SPX protocol might be used on your network.
Therefore, we strongly suggest you run the
PSAdmin
from any client computer and select
"
Manual Setup
" to specify the print server's IP
address (For more detailed information about
Manual Setup, please refer to Chapter 3).
2. If the solution described above is not applicable,
you have to follow the instructions below to set up
the print server's IP address.
For the purpose of explanation, we assume the NT server
is on Segment A and its IP address is 192.72.214.66
(subnet mask: 255.255.255.224), the print server is going
to be installed on Segment B, with IP address, for example,
192.72.214.100.
1. Find an unused IP address on Segment A for temporary
use in the following steps, for example, 192.72.214.68.
2. Connect your print server to Segment A as a networked
node.
