Model SH-2012AH-QG
Cutting Machine
（
C002
）
13
3.8.1HOLE
To pierce at the original position, which is often used for boring.
3.8.2MOVE HOLE
1
）
Operator may press [↑], [↓], [←] and/or [→] key to move the cutting torch to the edge of steel plate; in the mean time,
the speed multiplying factor is adjusted to 5% automatically. The system is preheated.
2
）
Press [START] key at the end of preheat. The cutting torch will reach the piercing point along a
straight line at selected cutting speed and then go on machining.
3.8.3NO HOLE
Instead of piercing, the system moves through the current piercing position to next, and new piercing prompt
appears.
Fig. 3.7 Option dialog box prompted by the system after reach piercing point if edge piercing method is selected
www.collectcnc.com
