Model SH-2012AH-QG
Cutting Machine
（
C002
）
15
manual mode as follows:
4.1.1
[↑], [↓], [←], [→] directional control keys and [G] Continue Key
Generally, if any of the four direction keys is pressed and held, appropriate axial movement will carry on
until the key is released. However, if [G] Continue key is pressed and highlighted before any direction key is
pressed, the cutting torch will keep moving even if the key is released. The movement will not stop until the
direction key is pressed again. If two axial movements are required, let one axial movement start first and then
press the direction key for the other axial movement. Two axial movement will go on simultaneously. In this
case, the axial movement of cutting torch will stop if the corresponding direction key is pressed while the other
axial movement will go on until the corresponding direction key is pressed too. [PAUSE] key will stop the
movement as well.
4.1.2
【
F1
】
AUTO
The system is switched to automatic mode.
4.1.3
【
F2
】
MOVE
If MOVE function(highlighted) is selected, the system will prompt to input MOVE INCREMENT:
0050.000 (previous input value by default). In MOVE mode, if direction key is pressed once, the cutting
torch will move an increment at the speed of the current maximum speed limit multiplied by multiplying
factor.
4.1.4 [F2]P-START, [F3]P-END and Calibration function
This feature is used when the steel plate is not positioned perfectly or the steel plate needs to rotate an angle
before machining. Let the cutting torch go along a straight edge as long as possible. Pick up two points([F2]
for setting P-START and [F3] for P-END). The system will calculate automatically the rotation angle. Select
the ROTATE function in automatic mode. After acknowledged, the system will start the machining program at
the appointed rotation angle.
Note: Counterclockwise direction is taken as positive angle.
4.1.5
【
F6
】
CLS-CO
Input X/Y coordinates with any value.
4.1.6
【
F5
】
ＭＤＩ
4.1.7 Speed
At the top left corner of the screen, it shows F×(speed multiplying factor in manual mode)=manual speed.
It is allowed to adjust the speed quickly by pressing [F] key in this window. A pull-down menu will appear with 8 speed multiplying
factors available for selection with [↑] and/or [↓] key: 5%, 20%, 30%, 40%, 50%, 60%, 80% and 100%. And then, press RETURN key
to acknowledge the selection.
www.collectcnc.com
