3
GETTING STARTED
Here is a Parts List followed by a list of the tools, equipment, hardware & supplies that you will need:
PARTS LIST
[1]
Motor Lift
[2
] Pump relay harness
[3
] Relays (2)
[4]
Rocker switch assembly with wiring harness
[5]
Spacer Block (Shim)
[6]
Manual
[7]
Safety Cable
Tools and Equipment:
1. Electric drill with 1/8, 3/16, 3/8 and 1/2 inch drill bits
2. Two ¾ inch wrenches
3. A Phillips head screw driver
4. For heavier motors, a hoist to lift the motor while installing the bracket
Hardware and Supplies: (not included)
4
–
½ inch diameter stainless steel Hex Cap Screws of the appropriate length***
4- ½ inch stainless steel Nylon insert nuts
8
–
½ inch stainless steel flat washers
1
–
Tube of clear RTV silicon for sealing the transom mounting holes (recommended)
1
–
Tube of dielectric grease for the electrical connections (recommended)
2
–
Security bolts that match the clamp bracket on your motor (recommended)
*** For proper bolt length selection see the information on the following page. ***
CAUTION!
On the hydraulic motor,
DO NOT
make an electrical connection to the boat’s
battery until all of the following steps are followed and you are instructed to do so in section (Making
Electrical Connections). Failure to follow these instructions could result in an electrical short or
damage to the hydraulic motor and/or boat components.
