14
WIRELESS REMOTE TROUBLE SHOOTING
Weak Signal:
1.
Battery may be low
. To replace battery, remove the screw on the back of the
transmitter. Remove the back cover carefully, noticing how the rubber membrane is
seated in the case. Remove and replace the battery. Reinstall back cover making sure
that the rubber membrane is seated in the case. Install screw and carefully tighten.
Do not over tighten.
Dispose of old battery properly. During periods of long
inactivity, it is recommended to remove the battery.
2.
Receiver is obstructed
. Move receiver in a direct line with the transmitter. Make
sure antenna is not obstructed.
3.
Programming the transmitter to the receiver.
1. Disconnect power to receiver (either positive or negative terminal).
2. Enable the transmitter by pressing the power button, the LED will flash twice.
3. Hold down either directional button on the transmitter.
4. While holding down button connect power for about one second.
5. You should hear a relay
on the receiver “click”.
6. Release button and fully reconnect power.
7. Your transmitter is now programmed to the receiver.
