AN241
www.hoperf.com
Copyright © By HOPERF
V0.4 | Page 24/41
CM T 23 10 A EB GU I
86 5M Hz 2 FS K 00 0
20 kb ps 10 kH z
Sl eep i ng no w
SLP
Figure 3-2. Sleep Mode Interface
（
CMT2310A enters into Sleep mode
）
Note
：
1. In this interface, pressing K1 again will not update the information while the firmware will send out Sleep
command again
；
2. In this interface, press K2 to make CMT2310A exit Sleep mode and return to the upper menu (that is, the
screen shown in Figure 3-1. To return to the main menu, press K2 again).
3. Because the CMT2310A-EM board is equipped with reserved Current Detect jumper terminals, the
Current consumption of the CMT2310A in Sleep mode can be tested under the combining situation.
3.2 CW Tx Mode
After selecting "CW Tx" mode, press K1
“ ”
in the main menu interface to enter the CW Tx working mode,
as shown in Figure 3-3 below.
CM T2 31 0A EB GU I
86 5M Hz 2F SK C W 000
+ 20 dB m
3. Tx mode
Tx
1. Frequency
band
2.Modulation/demodulation
mode
5. Tx power
6. Operation
guide
4. Chanel signal
Figure 3-3. CW Tx Mode Interface
