Club Car V-GLIDE, Maintenance Service Supplement

Page: 77 / 112

MOTOR Motor Installation
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement Page 15-13
15
4.2. Loosely install four motor bolts and washers that secure the motor to the transaxle. Do not tighten.
4.3. Begin finger-tightening the bolts (1 and 2) in the sequence indicated (Figure 15-19, Page 15-13).
Continue tightening by hand until the motor is seated in the transaxle housing. See following CAU-
TION and NOTE.
CAUTION
• Make sure the motor is properly seated in the transaxle housing.
NOTE: Failure to install and tighten the motor mounting bolts in the proper sequence and to the proper
tightness may result in motor noise during operation.
4.4. Tighten the bolt (24) inserted through the tab to 155 in-lb (17.5 N·m) (Figure 15-18, Page 15-13).
4.5. Tighten the center bolt (2) to 65 in-lb (7.3 N·m) (Figure 15-19, Page 15-13).
4.6. Tighten the right bolt (3) to 65 in-lb (7.3 N·m).
4.7. Tighten the left bolt (4) to 65 in-lb (7.3 N·m).
4.8. Install the motor wires, making sure they are connected to the correct motor terminals and that the
terminal orientation is correct. See Wiring Diagram, Section 11, Page 11-4. Tighten the terminal
retaining nuts to 65 in-lb (7.3 N·m).
Figure 15-16 Clean Chamfer and Input Shaft End Figure 15-17 Gap at Motor and Transaxle
Figure 15-18 Motor Installation Figure 15-19 Motor Mount
CHAMFER
SHAFT END
1/16 INCH (1.6 MM)
24
25
1
3
2
VIEWED
FROM
DRIVER
SIDE
4