Club Car V-GLIDE, Maintenance Service Supplement

Page: 39 / 112

ELECTRICAL COMPONENTS Wiper Switch
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement Page 12-9
12
4. To adjust surface contact, turn the adjustment screw (14) (Figure 12-9, Page 12-10) until the surfaces
of the wiper switch arm brush and fixed contacts are parallel (Figure 12-7, Page 12-9). See following
NOTE.
NOTE: If the wiper switch arm brush is worn to or beyond the wear limit line, it should be replaced
(Figure 12-8, Page 12-9). If any of the fixed contacts are excessively worn, pitted, or burned, the
entire wiper switch housing with fixed contacts must be replaced.
A thread locking compound has been placed on the threads of the contact studs to prevent removal
of the fixed contacts.
5. Proceed to Wiper Switch Adjustment.
Wiper Switch Adjustment
Each of the adjustments listed in the following WARNING affects V-Glide wiper switch adjustment. To ensure
proper vehicle operation, if any one item requires adjustment, all must be checked, and adjusted if necessary,
in the order listed.
∆
WARNING
• To properly adjust wiper switch, check and adjust if necessary, the following items in the
order listed:
- Brake pedal and cable adjustment. See Section 5 in the DS Golf Car Maintenance and
Service Manual.
- Accelerator rod adjustment. See Section 5 in the DS Golf Car Maintenance and Service
Manual.
- Accelerator pedal stop adjustment. See Section 5 in the DS Golf Car Maintenance and
Service Manual.
- Park brake adjustment. See Section 5 in the DS Golf Car Maintenance and Service Manual.
• Failure to check all adjustments in the order listed could result in improper vehicle operation,
property damage, or severe personal injury.
Figure 12-7 Wiper Arm Brush and Fixed Contacts Figure 12-8 Wiper Arm Brush Wear Limit Line
RIGHT WRONG WRONG
Wiper arm brush and fixed contacts
should seat firmly against each other.
WIPER ARM
BRUSH
FIXED
CONTACT
WIPER ARM BRUSH
WEAR LIMIT LINE
SIDE VIEW
WIPER ARM
BRUSH