Club Car Carryall 272 200, Owner'S Manual

Page: 33 / 40

Cleaning the Vehicle
2000 Carryall 272 Vehicle Owner’s Manual 27
Be sure battery clamp is properly tightened. Tighten to 12 ft.Ib (16.2 N-m). A loose clamp may allow the bat-
tery to become damaged from vibration or jarring.
If battery appears weak, have it charged by a trained technician. The battery should never be left discharged
any longer than absolutely necessary (do not leave discharged overnight).
CLEANING THE VEHICLE
The vehicle is equipped with an ABS/DR acrylic front body and an all-aluminum rear body and cargo bed.
Use only commercially available automotive cleaners and a sponge or soft cloth for normal cleaning. A gar-
den hose at normal residential water pressure is adequate.
Club Car does not recommend any type of pressure washing or steam cleaning. Such a process (especially
when the rear body of the vehicle has been removed) will expose electrical components to moisture. Mois-
ture entering electrical components can result in water damage and subsequent component failure.
Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should be
removed immediately to prevent possible stains.
The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm water
applied with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult stains or
scratches, blemishes, or other body damage, see the Carryall 272 Maintenance and Service Manual.
ACCESSORIES
There is a complete line of accessory equipment available from Club Car and our dealers/distributors. Care
should be taken that these accessories are properly installed by trained technicians, and that they are used
in the manner for which they were designed.
Figure 24 Battery Electrolyte Level
• DISPOSE OF WASTE WATER PROPERLY.
• CUSTOM CAB ASSEMBLIES, CANOPY TOPS, AND TINTED WINDSHIELDS WILL NOT
PROTECT OCCUPANTS FROM FLYING OBJECTS.
• IF THE VEHICLE IS EQUIPPED WITH AN ELECTRIC LIFT BED, REMOVE THE BED BEFORE
SERVICING THE BED LIFT SYSTEM.
ELECTROLYTE
LEVEL AT LEAST
1/2 IN. ABOVE
PLATES OR
TO LEVEL
INDICATOR
PLATES
LEVEL
INDICATOR
BATTERY
CAP
NOTE
WARNING