Club Car CARRYALL 252 2007, Owner'S Manual

Page: 32 / 52

Engine Oil
Page 30 2007 Gasoline Utility Vehicle Owner’s Manual
7. Use a 14 mm socket or wrench and replace the front oil drain plug, turning it clockwise, and tighten to
18 ft-lb (24.4 N·m).
8. Relocate the oil drain pan to a position under the engine oil filter (Figure 15) .
9. Remove the engine oil filter (1), turning it counterclockwise, allowing the residual oil in the filter port and
filter to drain into the oil drain pan (2) (Figure 16) . See following NOTE.
NOTE: An oil drip guard (3) can be used to prevent excess oil from dripping into the engine base plate.
Use an empty quart (one liter) container and cut the bottom off at an angle, then slide the open
area of the container up and under the oil filter prior to removing. Position the port of the plastic
container so oil will be directed into the oil pan. Or, make a drip guard by folding a piece of card-
board, thin metal, or plastic under the oil filter forming a channel to direct the filter port oil into the
drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Install a new oil filter (CCI P/N 1016467) onto the engine oil filter port. Apply a light coat of white lithium
NLGI Number 2 grease (Dow Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal
around the outside surface of the filter before attaching it to the oil filter port (Figure 17) . This will help
seal the filter to the oil mounting bracket.
NOTE: Use only Club Car oil filters (CCI P/N 1016467) designed for this engine.
12. Tighten the oil filter by hand until tight. Do not use a band wrench or channel lock plier to tighten.
13. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil
into the dipstick port. With filter change, the engine requires 38 ounces (1.12 liters) of oil per change.
Refer to oil viscosity guidelines for selection of oil grade (Figure 18) . Replace the dipstick.
Figure 16 Remove Engine Oil Filter
1
2
3