www.cls-led.com
www.cls-led.com
6
5
PROGRAMMING
FACTORY SETTING TABLE
All settings can be configured via DMX. Settings can be configured at once or separately. When one or a couple settings needs
to be changed just leave all other setting values zero. This keeps those settings unchanged.Please check the table for more
information.
Always use a DMX controller with digital interface. If not available, you can purchase the CLS D-ta DMX addresser unit (#122200).
First make sure to set the DATA on the DMX controller. To program the setting into the LED fixture follow the next steps.
2
* If all LEDs flash 10 times, something went wrong. Please try again. If the problem continues to occur, please contact your local sales distributor.
3
1
Place magnet
at one of the
indication marks.
All LEDs will
light up
After 2 seconds
all LED’s will flash
3 times
confirming
storage*
Repeat these
steps for the
3 other location
marks
2018 CLS-LED BV. All rights reserved. Information subject to change without notice, CLS-LED BV and all affiliated companies disclaim
liability for injury, damage direct or indirect loss, consequential or economic loss or any other loss occasioned by the use of, inability to
use or reliance on the information contained in this manual. No part of this manual may be reproduced, in any form or by any means,
without permission in writing from CLS-LED BV. Other legal information can be found in our General conditions, found on the back of
your CLS-LED BV invoice, inside the CLS catalogue or on our website www.cls-led.com/General-Terms.pdf
2
4
2 x
1
2
3
4
5
6
2 x
Front plate
Glas
Lens holder
Front plate
Glas
Lens holder
1
3
6x
Secure in
order
T20
T20
Make sure that
the items are clean
and the rubber
sealing is correctly
in place!
LENS REPLACEMENT
LENS INDEX
1
5
2
3
4
Superspot 8º
Medium Flood 30º
Spot 12º
Flood 61º
Extra wide flood 80º
5
Elliptical 12x46º
