Place the luminaire in the desired location, and using the 1/4" x
3/4” mounting slots and the appropriate fasteners, mount the
luminaire. Stainless steel fasteners are required, and should be
rated, so that each fastener can fully support the entire weight of
the luminaire.
IMPORTANT:
If mounting holes necessitate penetrating a
waterproof roofing or exterior surface, the installation contractor will
be responsible for maintaining the waterproof integrity of the roof or
exterior surface.
Mounting the luminaire
This luminaire is designed to
be securely fastened on each
of its four corners.
Rubber sealing plug, do not
remove unless it is being
replaced with a liquid tight
fitting, or being coupled to an
adjacent luminaire.
4
2
3
1
Page 2
8020 Queenair Drive
Gaithersburg, MD 20879
Ph: (800) 551-5012
Fax: (301) 963-3050
Email: [email protected]
ECLS Manual 6-08
c
2008 Cathode Lighting Systems
Insert the fastener through the luminaire and into the
hole and fasten tightly enough to secure the luminaire,
but loosely enough to allow movement back and forth
through the slotted mounting bracket. This movement
will be necessary for the procedure described on page
4 “Mounting Luminaires End to End”. Repeat for the
remaining three holes
