1/8” to 3/16”
Receiving your shipment
Please follow the instructions below. All shipments are F.O.B. Gaithersburg, MD.
If any damage has occured, you must immediately alert the shipper so that a claim may
be filed.
How to remove the polycarbonate lens
Loosen, (but do not remove) the screws which attach the two full-length retaining clips on each side of the luminaire. The
retaining clips can then be lifted up and tilted back from the luminaire allowing the tethered lens to be removed.
Approximately 1/8” - 3/16” of the screw thread will be visible below the shoulder of the lens fastener. This will allow the
lens fastener to be moved up and out of the way to remove the lens.
8020 Queenair Drive
Gaithersburg, MD 20879
Ph: (800) 551-5012
Fax: (301) 963-3050
Email: [email protected]
ECLS Manual 6-08
c
2008 Cathode Lighting Systems
1) Remove the luminaire from its packaging.
IMPORTANT: Please take all precautions to ensure that no water or moisture enters this luminaire during
installation. These luminaires are IP65 rated, and are water, and vapor tight. Any moisture that enters the
luminaire while the lens is removed, will be trapped inside after reinstallation of the lens. It is strongly
advised to install this product only when dry weather conditions prevail.
Page 1
