Once the lens has been properly positioned, return the two
lens retaining clips back to the vertical position and tighten
sequentially around the perimeter of the fixture. Tighten all
screws halfway, and then sequentially tighten all screws
until the bottom of the clip is drawn against the fixture (pic)
The exterior cathode light strip may now be energized.
Carefully replace the polycarbonate lens, making sure that the edges of the ends of the lens rest evenly at each end
within the gasketed channel.
Correct
End of lens sits evenly
spaced within the gasket
Incorrect
End of lens is too close to the
outside wall of the gasket
channel.
Incorrect
End of lens is too close to the
inside wall of the gasket
channel.
J. Reinstalling the polycarbonate lens
Installing the Lamp & Reinstalling the Polycarbonate Lens
Page 5
I. Installing the lamp
Snap the lamp in the lampholders, making sure good electrical contact is occurring at each end.
Using a flathead screwdriver, slide the lamp-lock clips into the locked position.
8020 Queenair Drive
Gaithersburg, MD 20879
Ph: (800) 551-5012
Fax: (301) 963-3050
Email: [email protected]
ECLS Manual 6-08
c
2008 Cathode Lighting Systems
