5.4.4 MOTION HOLD
•
Choose
the
MOTION HOLD
in the
MOTION
menu with the
UP/DOWN
buttons
•
Press
the
ENTER
Key button to set up the
MOTION HOLD.
.
•
Choose the time duration (1sec. ~ 15sec.) with
UP / DOWN
key buttons
•
After set-up the time duration, press the
ENTER
Key.
•
Press
the
ESC
button to exit.
5.4.5 AREA
•
Choose
the
AREA
in the
MOTION
menu with the
UP/DOWN
buttons
•
Press
the
ENTER
button to create the motion detection
AREA
.
•
Move the symbol “
O
” by using the
UP
/
DOWN
/
LEFT
/
RIGHT
buttons and select the
area where you would like to create, and press the
ENTER
button.
•
To release the motion detection area, press the
ENTER
button after moving the symbol
“
O
” to the same area where you created.
•
Press
the
ESC
button to exit.
NOTE
The
OSD
or
OSD+BUZZER
and the motion detection
AREA
should be selected
for motion recording.
The system will not save recorded data to the Hard Disk Drive (HDD) when the unit is set to the
improper recording mode (endless motion detection). To correct this, change the recording mode
to the Continuous Recording mode for most applications.
Please pay attention to the following directions in order to use the Motion Detection function
properly:
•
Adjust the sensitivity level and motion area to fit your requirements.
•
Do not use this function in an area where many objects are continuously moving. In case
of this, change the recording mode to the Continuous Recording mode.
•
Use a high quality camera that does not generate video static or “noise”. The motion
detection algorithm recognizes this “noise” as a motion and records the noise even if
there was no actual motion.
•
Do not point the camera toward a strong and changing lighting source; it can activate a
false motion detection.
Created Motion
detection area
- 25 -
