Benches are intended for installation against
the end of an island unit. It is finished on
three sides. However, in lieu of end-of-island
installation, the bench could be installed
against a closet wall.
Additionally, since the top shelf (seat) is
finished along three edges, you could create
one large bench with two units positioned
back to back.
PREP
ARA
TION
PAR
TS
QTY. PART DESCRIPTION
1 10 “ x 24” Drawer (sold separately)
2 Side Panels
16 Screw-in Studs (#56544)
1 Bottom Shelf
1 Middle Fixed Shelf
1 Backing Panel
1 Top Shelf (Seat)
2 #8 x 1-1/2” Screws
OPTIONAL
DRAWER RUNNER HOLES
1.
With both side panels positioned with
holes facing up, insert all screw-in studs
into the pre-drilled holes: 2 screw-in
studs at the bottom; 2 screw-in studs for
the middle shelf; and 2 screw-in studs for
the back panel. (See Fig. 1.)
NOTE: Thread all screw-in studs into holes until
the stop ring is snug with the partition face.
ASSEMBL
Y
Fig. 1
2.
Position top panel (top panel has rounded edges) with
holes facing up and insert four (4) screw-in studs into
the pre-drilled holes. See Fig. 2.
Fig. 2
24" drawers compatible with this bench are sold
separately. See “Drawer” in "Drawer and Door
Asssembly" section for instructions on assembling
the drawer to insert in the bench unit.
17-7/8”h x 26”w x 15-3/4 ”d
(excluding handle depth)
Use the cardboard packaging as a buffer between
the room floor and cabinet panels so that you
don’t scratch the laminate surface of the panels.
Bench
ACCESSORY ASSEMBLY
66
For optional drawer assembly:
Fasten
both drawer runners (using the 2 Euro
screws provided with the drawer
assembly) to the remaining pre-drilled
holes on both side panels.
ORDER OF ASSSEMBL
Y
£
Shelving /Towers
£
Drawers and
Doors
£
Top Shelves and Poles
£
Adjustable Shelves
£
Crown Molding
£
Baskets, Valet Rods,
Tie & Belt Racks, and
other accessories
£
Islands
¢
Benches
