CLO FABRIC KIT, Manual, Page: 14 / 14

1 3
7. HOW TO USE THE DIGITAL FORCE GAUGE
A. POWER - turn the Digital Force Gauge on/off
C. LED - turn the LED display on/off
D. UNIT - change the unit of measurement; Kgf is used to measure the stretch
FREQUENTLY USED BUTTONS
B. RESET
E. MODE
F. REVIEW
G. SETTINGS
I. SAVE
The following buttons are not used in the Stretch Test.
If one of these buttons are mistakenly pushed, reset the Digital Force Gauge with the Power button.
UNUSED BUTTONS
Use the provided adapter to charge the Digital Force Gauge.
CHARGING
The Digital Force Gauge uses the default settings as the image below. If a button was mistak-
enly pushed, power the Digital Force Gauge off, then on, to reset the device to its default
settings. However, if the default unit of measurement was changed, press button B to reset
the device to Kgf.
A B C
D E F
G H I
Once the test has been completed for a swatch, reset the Control Lever so the needle aligns with 0 on the
Length Ruler. Then unscrew the clamp at each end and remove the swatch. If you are finished testing you can
turn the Digital Force Gauge off. In between each swatch test you should turn the digital force gauge off and
then back on after the needle has been returned to the 0 mark.
Click Next to Continue.
7
8