CLIVET WDAT-iZ4, Manual For Installation, Use And Maintenance

Page: 31 / 72

31
6 START-UP
Start-up report
To detect the objective operational conditions is useful to control
the unit over time.
With unit at steady state, i.e. in stable and close-to-work
conditions, identify the following data:
x total voltages and absorptions with unit at full load
x absorptions of the different electric loads (compressors, fans,
pumps etc)
x temperatures and flows of the different fluids (water, air) both
in input and in output from the unit
x temperatures and pressures in the feature points of the
cooling circuit (compressor, liquid, suction drain/unload)
The detections must be kept and made available during
maintenance interventions.
Directive 2014/68EU PED
Directive 2014/68EU PED also sets out the regulations for unit
installers, users and maintenance operators.
Refer to local regulations; briefly and as an example, see the
following:
Compulsory verification of the first installation:
x only for units assembled on the installer's building site (for ex.
condensing c direct expansion unit)
Commissioning declaration:
x for all units
Periodical checks:
x
to be executed with the frequency indicated by the
Manufacturer (see the “maintenance inspections” paragraph)