Page 14
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
,
Inc.
* Consult the TESLA
®
Wall Connector Manual if selecting the TESLA
®
Load Sharing Option.
CONFIGURATION F:
Required Equipment for a Single-Mount Pedestal with one
TESLA
®
EVSE (One EVSE per Pedestal):
•
One (1) ClipperCreek ProMountDuo™ Kit, ClipperCreek part number
0300-00-025.
•
One (1) TESLA
®
EVSE, TESLA
®
part number 1050067-01-E.
•
One (1) dedicated 208, 240 or 277V AC branch circuit.*
•
One (1) circuit breaker appropriately sized for the EVSE charging capacity.*
•
Two (2) Live Line conductors that are appropriately sized based on the EVSE
power requirements (5 feet of length is adequate).
•
One (1) Ground Line conductor with enough length to comfortably pull all
the way through and above the top of the pedestal (5 feet is adequate).
•
Conduit sized to fit all conductors.
•
Four (4) Anchor Bolts with Nuts and Washers (additional washers may be
required for leveling)
CONFIGURATION G:
Required Equipment for a Dual-Mount Pedestal with two
TESLA
®
EVSE (Two EVSE per Pedestal):
•
One (1) ClipperCreek ProMountDuo™ Kit, ClipperCreek part number
0300-00-025.
•
Two (2) TESLA
®
EVSE, TESLA
®
part number 1050067-01-E.
•
Two (2) dedicated 208, 240 or 277V AC branch circuits.*
•
Two (2) circuit breakers, appropriately sized with respect to the charging
capacity of each EVSE.*
•
Two pairs (2x2) Live Line conductors (one pair for each EVSE) that are ap-
propriately sized based on the EVSE power requirements (5 feet of length is
adequate).
•
Two (2) Ground Line conductors (one for each EVSE) or a single bonded
Ground Line with enough length to comfortably pull all the way through and
above the top of the pedestal (5 feet is adequate).
•
Conduit sized to fit all conductors.
•
Four (4) Anchor Bolts with Nuts and Washers (additional washers may be
required for leveling)
Single TESLA
®
EVSE
Dual TESLA
®
EVSE
CONFIGURATION G
INSTALLATION REQUIREMENTS AND CONFIGURATIONS
(continued)
CONFIGURATION F
