Page 7
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
,
Inc.
TOOLS REQUIRED FOR ASSEMBLING THE ProMountDuo™
PEDESTAL WITH CLIPPERCREEK HCS, LCS/ACS, OR
TESLA
®
EVSE
The following tools are required for the installation and assembly of the ClipperCreek ProMountDuo™
pedestal components.
•
Ratcheting Low-Profile Driver with T25 and T30 Torx bits (there are some tight spaces). IF USING
HIGH POWER TOOLS ON THE TORX SCREWS, USE WITH CARE, ON A LOW TORQUE
SETTING, AS THEY MAY STRIP AND/OR DENT THE SURFACES OF THE PEDESTAL.
•
3/16” Hex Wrench (Allen key)
•
Socket Wrench (appropriately sized for the customer-supplied Anchor Nuts)
•
Installers Preferred tools for flexible conduit trimming
• Installers Preferred tools for knockout removal
• Level
• Tape Measure
•
Base Cardboard Template (included in the ProMountDuo™ packaging; this template can be found and
punched out fom the Cap and Base cardboard packaging)
• REQUIRED IF INSTALLING LCS/ACS AND TESLA
®
EVSE
: Silicone for sealing Conduit.
• TESLA
®
EVSE only: T10 Torx Driver and T20 Security pin Torx Driver
•
OPTIONAL: ClipperCreek CP-50 EVSE Tester (ClipperCreek part number 0500-03-000)
•
ProMountDuo™ PEDESTAL INSTALLATION GUIDE:
CLIPPERCREEK HCS, LCS/ACS AND TESLA
®
EVSE
CONFIGURATIONS
CONFIGURATION A:
Single ClipperCreek HCS EVSE (dimensions shown in
Figure 1
)
CONFIGURATION B:
Dual ClipperCreek HCS EVSE (dimensions shown in
Figure 1
)
CONFIGURATION C:
Single ClipperCreek LCS/ACS EVSE (dimensions shown in
Figure 2
)
CONFIGURATION D:
Dual ClipperCreek LCS/ACS EVSE (dimensions shown in
Figure 2
)
CONFIGURATION E:
Combo ClipperCreek HCS and LCS/ACS EVSE
(extrapolate dimensions using
Figure 1
and
Figure 2
)
CONFIGURATION F:
Single TESLA
®
EVSE (dimensions shown in
Figure 3
)
CONFIGURATION G:
Dual TESLA
®
EVSE (dimensions shown in
Figure 3
)
CONFIGURATION H:
Combo ClipperCreek HCS and TESLA
®
EVSE
(extrapolate dimensions using
Figure 1
and
Figure 3
)
CONFIGURATION I:
Combo ClipperCreek LCS/ACS and TESLA
®
EVSE
(extrapolate dimensions using
Figure 2
and
Figure 3
)
