VERS. 2018.05
CM70 ALU_MAN_EN
16
In no case should the water pump run empty. Therefore, ensure that the water level in the tank
never falls below the water suction of the pump.
If there is a risk of frost, please empty the blade cooling system completely.
During cutting operations, many impurities accumulate in the bottom of the tank. It is then
necessary to frequently change the water in order to guarantee the proper functioning of the
pump and optimal cooling of the blade. The tank is equipped with a drain plug which facilitates
this task.
4
TRANSPORT AND STORING
Take the following measures in order to transport the CM70 ALU securely.
4.1 Securing for transport
Before transporting or lifting the machine, always remove the blade and empty the water pan.
The conveyor cart must be secured:
move the conveyor cart to the end of the machine
fix it using the pin on the rear post of the chassis and the eye screw on the conveyor cart.
4.2 Transport procedure
The machine can be moved on a flat surface using its wheels. Only use the lift brackets to lift the
machine, as other parts of the machine are not designed for this purpose. The machine is not
intended to be transported by crane.
4.3 Long period of inactivity
If the machine is not going to be used for a long period, please take the following measures:
Completely clean the machine
Empty the water system
Take the water pump out of the slurry and clean it thoroughly.
The storage site must be clean, dry and at a constant temperature.
