VERS. 2018.05
CM70 ALU_MAN_EN
8
2
MACHINE DESCRIPTION
Any modification, which could lead to a change in the original characteristics of the machine, may
be done only by Saint-Gobain Abrasives who shall confirm that the machine is still in conformity with
the safety regulations.
• Raise and lower the cutting unit at different heights.
• Possible to adjust the cutting length by bringing the cutting unit closer.
• The material-holding table or cart has “U” shaped rollers that fit snugly into the slides.
• With 4 removable legs for easy transport.
• The cart is equipped with a graduated ruler that allows you to cut pieces at an angle.
• Equipped with a housing with racks for cooling the cutting blade.
• Machine protected against splashing by a curtain. Avoids the spraying of water towards
the rear of the machine.
• Electrical components comply with EU safety standards.
• The material-holding table or cart is equipped with a safety element, which prevents any
movement on the slides during transport.
• The material-holding table or cart is designed with an anti-tipping system. This device
prevents the cart from falling or tipping over when the pieces to be cut are too large or
poorly supported.
• This machine model is manufactured according to European directives.
• All motor bearings are sealed which gives them maximum service life.
2.1 Short description
The CM70 ALU block saw is designed for durability and high performance for onsite wet cutting
operations of a wide range of masonry, refractory and natural stone products.
As with all other NORTON products, the operator will immediately appreciate the attention given to
detail and quality of materials used in construction. The machine and its component parts are
assembled to high standards assuring long life and minimum maintenance.
2.2 Purpose of use
The machine is designed for cutting a large range of building and refractory materials. It is not
designed for cutting wood or metals.
