Climit 24 BF, User Instructions

Page: 79 / 152

79
EN
120
Ø 80
A B
C D
Ø 80
K
L
Fig. 33
Description 24 BF 28 BF 38 BF
K (mm) 203 221 245
W (mm) 400 450 450
A (mm) 190 190 170
B (mm) 190 190 170
C (mm) 125 125 165
D (mm) 125 125 165
6.12 Electrical connections
The power cable must be connected to a 230V (±10%) ~ 50 Hz
network, observing L-N polarity and the earth connection. The
network must have an omnipolar switch with category III overvol-
tage, in compliance with the installation rules.
If this cable needs to be replaced, an original spare must be re-
quested from
Climit
.
Therefore only the connections of the original components as
shown in the table are needed. These are to be ordered separately
from the boiler.
DESCRIPTION CODE
External sensor kit (ß=3435, NTC 10KOhm at 25°C) 8094101
Power cable (dedicated) 6323875
Remote control HOME (open therm) 8092280
Remote control HOME PLUS (open therm) 8092281
m
CAUTION
The maintenance interventions described must ONLY be
carried out the professionally qualified personnel.
a
WARNING
Before carrying out any interventions described:
– set the main system switch to "OFF"
– close the gas valve
– make sure that no hot parts inside the appliance are
touched.
OFF
Fig. 34
To facilitate introduction of the connection wires of the optional
components into the boiler:
– remove the screws (1), pull the front panel (2) forwards and re-
lease it from the top by lifting it
1
2
Fig. 35