33
When set as
“Enable”, Mobile Lite auto answer an incoming call
(after the first ring) within the callback timer, and wait for the correct
Access Code (default: 1111) and
#
key entry within 15 seconds
before it opens a full-duplex Two-way communication. If the correct
Access Code (and the # key) are not entered within 15 seconds, the
system will disconnect the call automatically.
Auto Check-In Interval:
You can select the length of the interval between auto check-in
reports to CMS.
When the Mobile Lite makes the auto check-in report to CMS, its
location info will also be updated and sent with the report.
There will be no auto check-
in report if you select “Disable.”
Whenever Mobile Lite is programmed, the auto check-in timer will be
reset.
Auto Check-In Offset:
After Mobile Lite is rebooted, reset or programmed, the system will
start counting down the time for the first Auto check-in report.
Mobile Lite will send the first check-in report according to the setting
of Auto Check-In Offset time. Afterwards, Mobile Lite will send
reports according to the setting of Auto Check-in Interval
Fall Sensor Sensitivity:
Select a preferred sensitivity level for the learned-in Fall Sensor FS-3.
(5 is the highest sensitivity level while 1 is the lowest sensitivity
level.)
After setting the sensitivity level from the Control Panel, please press
and hold the button on the fall sensor for 8 seconds to receive the
sensitivity level data from the Control Panel. (Refer to the Fall
Sensor FS-3 user manual to complete sensitivity setting.)
Guard Time Sound:
Select “on” to enable beeps during guard time or “off” to disable the
beeping sound during guard time.
Confirmation Sound:
Select “on” to enable confirmation beeps during reporting or “off” to
disable confirmation beeps during reporting.
Mobile Silent
When this function is set to
“On”, silent mode is turned on where all
sounds are silent.
