Climax FF1200, Operating Manual, Page: 45 / 126

Machine assembly
P/N 95936, Rev. 0 Page 31
3.3.4 Attaching the chucking feet
After determining the chucking range, do the following to attach the chucking feet:
1. Turn the RDU upside down
(Figure 3-7).
2. Place the chucking foot
with the setup finger side
down on the RDU (Figure
3-8).
3. Insert the two chucking foot
screws through the correct
chucking range holes (Fig-
ure 3-8), and turn them into
the RDU. Tighten both
screws to 36 ft-lbs (49 Nm).
4. Turn the jam nut away from
the chucking foot body.
5. Turn the chucking foot set-
screw to retract the chuck-
ing foot all the way open.
6. Repeat steps 2-5 for each
chucking foot.
7. In small increments, turn
opposite pairs of chuck-
ing foot setscrews to
adjust the distance
between opposite pairs of
chucking feet to slightly
larger than the workpiece
diameter (Figure 3-8).
F
IGURE
3-7. RDU
INVERTED
(FF1200
SHOWN
)
F
IGURE
3-8. RDU
WITH ALL CHUCKING FEET ATTACHED
(FF1200
SHOWN
)