1130CC.COM / 1250CC.COM
10
V-Gauge Lite Manual V1.2
© 2008 Cliftech Design
Figure 10 shows a map of the V-Gauge Lite functions to which the drag timing screens have
been added. To enter the drag timing mode, hold the upper button for at least 2 seconds from
the RPM graphical screen shown in Figure 4. The bike must be stopped. This will switch the V-
Gauge Lite to the drag data review screens, allowing you to see the measurements from the last
run.
As usual, the lower button advances the display through the available screens. Holding the
upper button for at least 2 seconds in any one of the drag data screens resets the drag timer
and brings up the “READY” screen to time a new run. The drag data can only be reviewed while
the bike is stopped. As soon as the bike starts rolling, the display is returned to the RPM
graphical screen.
Timing data screens
The first 4 data screens show the measured times for the 60ft, 330ft, 1/8mi, and 1/4mi
distances. Figures 11-14 shows each of these screens. In each case, the time (1/10s) is shown
at the end of the first display line and the recorded gear position for that distance is shown at
the beginning of the second line. The speed is at the end of the second line, to the right of the
gear position.
Figure 11
– First drag timing data screen (60 feet).
Figure 12
– Second drag timing data screen (330 feet, 1/16 mile).
