1130CC.COM / 1250CC.COM
4
V-Gauge Lite Manual V1.2
© 2008 Cliftech Design
2. Button controls
There are two buttons on the left side of the gauge front. These are referred to as the “upper”
and “lower” buttons. The lower button always has the function of switching between different
screen displays within a given mode. The upper button is used to switch between modes or to
reset the data for a display screen. The bottom button works immediately. The top button
always needs to be pressed and held for at least 2 seconds.
3. Normal Operation
Figure 1 shows a map of the normal operation functions. It might at first look complicated but
stop and look again. It is really very simple. There are only 5 basic run screens, a trip
odometer reset function, and a maximum temperature reset function. The following section
describes these in more detail.
Start-up screen
When the V-Gauge Lite is first powered on by turning the bike’s key switch, a start-up screen is
displayed. This screen is shown in Figure 2. After the 1130CC.COM intro, this screen is
displayed for 3 seconds and then automatically switches to the shift point/odometer screen.
Figure 2
– Introduction screen shown for 3 seconds after power up. A small screwdriver can be used to
adjust the screen contrast through the opening on the right.
Shift point adjustment and odometer
As long as the V-Rod ignition key is in the on position and the engine off/run switch (right
handlebar control) is in the off position, the RPM adjustment screen is displayed. In this screen,
the lower button decreases the RPM at which the shift indicator is activated (in steps of 10) and
the upper button increases the RPM. As shown in Figure 3, the odometer is also displayed at
the bottom of this screen. This is the permanent, non-resetable odometer as opposed to the
trip odometer that will be described later in this section.
