www.directed.com
12
ultrasecure immobilizer
The UltraSecure immobilizer circuit in this G5 system is a unique new design that
incorporates the immobilizer security of Clifford without the possibility of failure due
to power loss that could potentially strand the user.
The level of security can be set by leaving in or removing the jumper located next to
the immobilizer wires exiting the module.
immobilizer jumper setting
jumper in setting
When the jumper is in, the ignition and starter signal will bypass the UltraSecure
immobilizer circuitry and allow the vehicle start and run, even if power has not been
restored to the module.
jumper out setting
When the jumper is out, the UltraSecure immobilizer circuitry prevents the ignition
and starter signal from passing and keeps the vehicle immobilized until power has
been restored to the module.
N
NO
OTTEE:: In order for the system to bypass the immobilizer with the jumper in place, the
unit must have ground on the 18-pin harness.
door lock harness wire connection guide
___
___
___
IIM
MPPO
ORRTTA
AN
NTT!! The door lock outputs are low current and should not be attached direct-
ly to any high-current device; they are only to be used to activate relays.
BLUE
(-) Unlock, (+) Lock Output
EMPTY
(+) 12V Protected, Low Current for 451M
GREEN
(-) Lock, (+) Unlock Output
H3/1
H3/2
H3/3