© 2004 directed electronics, inc.
59
If headliner mounting is not possible, the sensor can be placed in a lower area of the
vehicle, but field size and sensitivity may be affected. The armrest of the center con-
sole may be appropriate.
N
NO
OTTEE:: Never place the sensor behind any metal brackets or under console pockets
that will have coins or other metal objects in it.
adjusting the proximity sensor
It is recommended that adjustments be performed away from fluorescent lighting,
large metal structures, or confined areas that can affect the sensor field. The proxim-
ity sensor field takes about one to two minutes to settle after it receives power. Make
the first adjustment with the remote control after about 45 seconds. If the alarm does
not see an adjustment signal, it will exit adjustment mode after 60 seconds. Make the
adjustments slowly to let the sensor field settle. Each zone has 32 settings that are indi-
cated by chirps that raise and lower in frequency as adjustments are made.
If the alarm exits adjustment mode automatically it will revert to its previous settings.
To lock in the new settings, you MUST exit using the
button after programming!
The total adjustment time for this sensor should be 5 minutes or less. Taking the time
to properly adjust this state-of-the-art sensor will give your customer years of unsur-
passed security and stop any returns for further adjustments.
1.
Disarm system
2.
Transmit Channel 16. (Press
3 times then
1 time)
z
The LED will turn on and the siren will chirp 1 time.
z
Primary (full trigger) zone adjustment has now been entered.
z
Primary zone can now be adjusted.
3.
To adjust Primary Zone
z
Press
of the remote control to increase sensitivity.
z
Press
of the remote control to decrease sensitivity.
z
The sensor Primary zone can be tested at any time during adjustment and
will generate 1 siren chirp each time the zone is activated.
4.
Press
to adjust Warn-Away zone
z
Siren chirps 1 time.
z
Warn-away Zone adjustment has now been entered.
z
Warn-away Zone can now be adjusted.
