Disassembly
2 - 12 Removing and Installing a Processor
2.Disassembly
Processor Installation Procedure
1.
Insert the CPU
(
Figure 8a
), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
IT!), and turn the release latch
towards the lock symbol
(
Figure 8b
).
2.
Insert the heat sink
at an angle of around 30° as indicated in
Figure 8c
.
3.
Tighten the CPU heat sink screws in the order
,
&
(the order as indicated on the label and
Figure 8d
).
4.
Replace the component bay cover.
A
B
D
1
2
3
b.
B
a.
D
Note
:
Tighten the screws
in the order as indi-
cated on the label.
A
c.
d.
1
2
3
Figure 8
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Insert the heat sink.
d. Tighten the screws.
A. CPU
D. Heat Sink
•
3 Screws
Summary of Contents for W130HU
