Clever Electronics NPM2000, User Manual

Page: 14 / 28

NPM Manual
Press search all NPM units of the same network. And list these
u address, etc. Double click a
cert right.
Con , subnet mask, gateway, work port, reset port, etc.
nits.The list contains module type, IP address, physics
ain NPM, it will show the main parameters of this NPM at “Property” section at
tain IP address
Is search via specified IP, the right blank fill the
specified IP.
Explanation of items as following:
Item
Name Default Value Explanation
Password 88888
You must enter correct password before
modifying other items. The password can
reach 9 bits. And you can
use a~ z, A~Z,
0~9 etc.
New Password
No
You must choose “Yes” firs on the
right side. Then you can fill ”New
password” and “Confirm new password”.
Password
Operation
Verify No Confirm new password
IP Address 192.168.0.178
You cannot fill X.X.X.0 or X.X.X.255. IP
address is address in the network for
network devices such as PC and NPM,
etc. It is exclusive in the same network.
Mask 255.255.255.0
Subnet mask is very important for the
network. The value of subnet mask is the
same with IP address
in the same network. So you must set the
IP address and subnet mask correctly.
Gatewa
Fill the gateway’s IP address or router
y 192.168.0.1
address of home network.
Port 4001
by other network agreements. Thes
You can fill 1~65535, some are occupied
e
occupied ports can’t be used. More
relative details please refer appendix.
IP Configure
Reset Port 3003
Reset port. Can fill 1~65535. Some ports
are occupied by other
network agreements. These occupied
ports can’t be used. More details please
refer appendix.
Baud rate 19200 Can choose 9600 19200
Check Bit NONE
There are 5 items. You can choose “No”,
“even”, “odd”, “force configure to 1”, “force
configure to 2”
Data Bits 8
Mean the availability data bits which
through the serial port. You can choose
5,6,7,8.
Config of
Serial Port
for
communicatin
g
network and
NPM
Stop Bits 1
There are 2 choices; 1 bit and 2 bits.
(Mean the length of stop bit)
If you modified parameters in the “Properties” menu, you must click in the
Page 14 of 28