Figure 3-8
Fan Guard/Air Diverter Shown in Installed Position
The fan guard helps protect the operator from injury caused by the rotating fan blades.
Never operate a Connectionless Chef without the fan guard properly installed.
Operating a Connectionless Chef without the fan guard properly installed can cause injury,
equipment damage, and reduced performance.
H. Install the Fan Guard/Air Diverter
1. Hold the fan guard so that the large ends of the keyholes are towards the bottom of the steamer.
2. Place all four openings over the mounts located on the rear wall of the steamer
3. Pull it down so that the narrow ends of the slots are pulled tight over the mounts. See Figure 3-8.
I. Install/Remove the Slide Racks (Pan Racks)
•
See Figure 3-9. Each rack has four loops; two
top and two bottom.
1. Hold the slide rack so the ends of the hanger
loops are towards compartment wall.
2. Slide one rack into the cooking compartment
with the loop side closest to the compartment
wall and rack slots horizontal.
3. Hook the loops over the top and bottom pins
4. Repeat steps 1, 2, and 3 for the other rack.
J. Install/Remove the Bypass Shield
Note:
Bypass Shield should be installed when cooking with solid bottom pans.
•
By Installing the Bypass Shield the Connectionless Chef will consume less water resulting in
fewer reservoir refills during cooking.
•
To
Install/Remove
, slide the Bypass Shield on the bottom Slide Rack (Pan Rack) slot so that it is
just above the KleanShield™ as shown in Figure 3-10.
FAN GUARD SHOWN
PULLED DOWN TO
LOCK IT IN PLACE
FAN GUARD
LARGE END OF KEYHOLES
AT BOTTOM
Figure 3-9
Slide Rack Installation
Figure 3-10
Bypass Shield
Installation
8
