Cleveland MKEL-100-T, Operator'S Manual

Page: 8 / 43

OPERATING INSTRUCTIONS
Cleveland
DIGITAL WATER METER
MIN.
FAST
9
8
7
6
5
4
3
2
1
SPEED CONTROL
L
I
F
T
M
IX
ER
LIF
T
OFF
OFF
MIX LIFT
UP DOWN
MA
IN
PO
W
ER
OFF ON
EM
ERG
EN
C
Y
STO
P
MOTOR WILL NOT START UNLESS CONTROL IS AT "MIN."
20
1
4
5
3
17
2
21
22
24
23
25
19
9
12
13 10
11
6
16
14
15
7
8
18
General Parts Drawing
(some parts shown are optional)
ITEM # DESCRIPTION FUNCTION
1. Main Power Switch Power switch for unit.
2. Mix/Lift Switch Sets hydraulics to mix or lift mode.
3. Up/Down Switch When unit is in lift mode, mixer bridge can be raised or lowered with this switch.
4. Mixer Speed Control Dial Controls speed of agitators and mixer bridge lift.
5. Emergency Stop Button Stops hydraulic system (agitators and mixer bridge lift).
6. Mixer Bridge Encloses agitator motors.
7. Main Agitator Arm Provides most of the product movement.
8. Secondary Agitator Arm Provides reverse agitation and product lift in kettle.
9. Secondary Speed Control Knob Controls speed of secondary agitator arm.
10. On/Off Heat Switch Controls electrical power (heat) to kettle.
11. Heat Indicator Light (Green) When lit, indicates that the kettle burner is on. Cycles ON-OFF with burner.
12. Solid State Temperature This control allows the operator to adjust the kettle temperature in increments
Control Knob from 1 (Min.) to 10 (Max.). (see Temperature Range Chart).
13. Low Water Indicator Light When lit, indicates that the kettle is low on water and will not operate in this
(Red) condition. This will also light when the kettle is tilted.
14. Faucet Spout Delivers water to the kettle.
15. Hot Water Valve Turns on hot water.
16. Cold Water Valve Turns on cold water.
17. Tangent Draw-Off Valve Used for draining product or wash water from kettle.
18. Power Tilt Control Switch Used for tilting the kettle up or down. Replaced by hand tilt wheel on manual tilt units.
19. Vacuum/Pressure Gauge Indicate steam pressure in PSI inside steam jacket as well as
vacuum in inches of mercury.
20. Interrupt Switch Interrupts flow without resetting water meter.
21. Start Switch Starts water flow to kettle.
22. On/Off Switch Power switch to water meter.
23. Water Meter Control Display and setting for water meter.
24. Active/Bypass Switch Switch to activate or bypass (manual operation) the controller.
25. Temperature Controller Digital temperature control and indicator.